Here is my first loading of some nosler custom competetion 190gr with 53gr of h4831 .010 off the lands. each brass, bullet, and powder all within .1grans. Have a latter test planned but needed something to get me on target with this remington 700 adl.
![Image](http://i.imgur.com/nN0jNmh.png)
target 1 sorry for all the mess on it small holes up and left are 223 just playing with the ar. the 5 holes to the right of bullseye are winchester 150gr hunting loads. with no change to the scope the three holes at the bottom of the target are the loads mentioned at the top of this post
![Image](http://i.imgur.com/MGxsNLH.png)
same holes covered with a penny
![Image](http://i.imgur.com/TFnASsu.png)
same load at 200yds
![Image](http://i.imgur.com/rvmcQW3.png)
and thats where i ran out of 53 grain loads. and for what its worth this is the best group i have ever shot, and only bolt action gun i have ever owned. The stock barrel is free floated and i added 2.85lb of weight to help with recoil. otherwise its a bone stock 700 adl with a cheap 4-16 bsa scope.
Over all I am thrilled with the gun and how it performed with these hand loads performed. I measured the groups today and the 100yd was .5625" and 200yd was 1.25". Hopefully with any luck I will be able to get the groups a little tighter and be able to get out to 600 yds in the next few outings. I would really like to make it to 1000 yds by the end of the summer and make hits on a 24"x24" plate.
for what its worth based on drop from 100-200 the 190gr bullets are leaving the muzzle at 2390fps. Would like to get that number up to 2600 or better if possible.