She wants to move her craft area upstairs to a spare bedroom that is going to be turned into an office/craft area.
That being said, she found a couple different designs that she liked. She settled on the one that I'm going to track in this build thread.
I'll try to be somewhat detailed about what materials it takes to finish and the timeline. I haven't purchased all of the materials at the time of the project start.
Materials/tool list at the beginning of the build:
10" Delta contractor table saw
Mitre gauge
Circular saw
Track to crosscut sheet goods
Router/router table
Impact driver
Drill
Pocket hole jig
Air compressor/nail guns
Various clamps
Squares
Tape measure/ruler
Shelf pin jig/drill bit
Heat gun
4 sheets of 3/4" cabinet plywood
2 sheets of 1/2" cabinet plywood
500 pocket hole screws
Glue
Veneer edging tape
Piano hinges
Screws
Additional materials
32 bf of 1x6 poplar to build doors
One note about planning this or any project. I wish I was better at using the Sketch-up design tool for a complete project plan at the start. I've tried to learn to use it but haven't been able to get to a finished design with a materials list and cut list. I need to do more of the tutorials to get better at it. For now, I sketch on grid paper and guesstimate the materials and cut lists.
Here we go:
This is what the craft center is supposed to look like.
![Image](http://uploads.tapatalk-cdn.com/20170404/eeba719d683534fdad2fc256f218730a.jpg)
![Image](http://uploads.tapatalk-cdn.com/20170404/afb94afbf8547406544514c096fecc3c.jpg)