Page 1 of 1
M92 PAP Pistol
Posted: Sat Feb 28, 2015 10:36 am
by Smithengineered
Has anyone on here SBR'd a M92 pistol? I'm looking at doing this in the near future, but wondering if I need to swap out the trunnion? I'm going with a stormwerkz folding mechanism. Looking at the inside of this does not look like it has much meat to hold a stock....
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 11:24 am
by jmeister
Seen quiet a few just drill & tap the rear trunnion. That's how I did my Draco, dunno if the thickness is similar or not to the PAP. I'm not planning on doing pull ups with it or breaking off doorknobs though either.
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 1:43 pm
by Smithengineered
jmeister wrote:Seen quiet a few just drill & tap the rear trunnion. That's how I did my Draco, dunno if the thickness is similar or not to the PAP. I'm not planning on doing pull ups with it or breaking off doorknobs though either.
I looked in my Draco and it's much beefier than my M92. Same here on not trying to do any heavy duty stuff with it.
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 6:55 pm
by guncrank1
Change the turrion
May require holes welded up though.
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 7:38 pm
by kokopelli
easiest/cheapest sbr on those is the VZ58 side fold stock, that has the single, large threaded screw. Drill and tap on the rear end....bam.
Check out Meridian...they did one this way. Pics are on here somewhere...
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 7:40 pm
by kokopelli
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 8:30 pm
by Smithengineered
guncrank1 wrote:Change the turrion
May require holes welded up though.
That's the answer I was afraid of lol
Re: M92 PAP Pistol
Posted: Sat Feb 28, 2015 8:32 pm
by Smithengineered
Thanks. Looks decent, but I'm a bigger fan of this lol